V9438

Magnetic Drilling Machine

The handle lever handle base screw holes screwed before use, tighten, turn the handle, check whether the guides freedom of movement (slide up and down of the new machine will be feeling a little tight). Electrical power, to open the magnetic switch. Open magnet switch, indicator lights, and show that the magnet is in working condition, with iron bars on the magnet at the bottom, check for suction. Open drill switch, to check electric drill normal operation.
Note: Move magnetic base, do not drag on the ground, to prevent magnetic damage.

Model	V9438
Rated voltage	110/230V
Rated frequency	50/60Hz
Motor input power	1050W
No load speed	0-500/0-800r/min
Max. drilling diameter	38mm
Tap capacity	M4-M16
Max. attraction	12000N
Max. travel	180mm
Rated axis taper	MT2
N.W.	19.8kg
Packing size	39x19x48cm

Instruction
1. Use voltage: line voltage does not exceed ±5% of the voltage specified on the nameplate.
2. Use chuck or drill according to the mode of drills.
3. Use the drill bit must be sharp, electric drill for some reason suddenly brake or stuck drill, you must immediately shut down the drill switch (Note: Be sure not to turn off the magnetic base switch).
4. Carbon brush can not be used, to be promptly replaced (two brushes should be replaced at the same time).
5. If magnetic drill failure, should be repaired, and can not be used before the unrepaired.
6. The magnetic drill must be keep clean.