MAB50

Magnetic Drilling Machine

The handle lever handle base screw holes screwed before use, tighten, turn the handle, check whether the guides freedom of movement (slide up and down of the new machine will be feeling a little tight). Electrical power, to open the magnetic switch. Open magnet switch, indicator lights, and show that the magnet is in working condition, with iron bars on the magnet at the bottom, check for suction. Open drill switch, to check electric drill normal operation.
Note: Move magnetic base, do not drag on the ground, to prevent magnetic damage.

Model	MAB50	MAB80
Characteristic: Overcurrent torsion protection, Magnetic induction lamp.
Rated voltage	110V/230V	110V/230V
Rated frequency	50/60Hz	50/60Hz
Motor input power	1150W	1500W
Aggregate input power	1260W	1620W
No load speed	250/450r/min	210/330/470/740r/min
Max. drilling diameter	50mm	80mm
Twist drill	23mm	32mm
Max. attraction	12000N	18000N
Max. travel	150mm	180mm
Rated axis taper	MT2	MT3
N.W.	12kg	25kg
Packing size	31x16x44cm	31x16x44cm

Instruction
1. Use voltage: line voltage does not exceed ±5% of the voltage specified on the nameplate.
2. Use chuck or drill according to the mode of drills.
3. Use the drill bit must be sharp, electric drill for some reason suddenly brake or stuck drill, you must immediately shut down the drill switch (Note: Be sure not to turn off the magnetic base switch).
4. Carbon brush can not be used, to be promptly replaced (two brushes should be replaced at the same time).
5. If magnetic drill failure, should be repaired, and can not be used before the unrepaired.
6. The magnetic drill must be keep clean.